Stacko™ setup is quick & simple
Step 01
Inspect all components for damage and serviceability.
Step 02
Before using these products you must perform your own risk assessment.
Step 03
Position the base on a solid, level surface suitable for the expected load being supported.
Place 3 Stacko™ Blocks in the Base Pad grooves to complete the first layer.
Step 04
Begin the second layer by placing another 3 blocks in the opposite direction of the first layer.
Step 05
Simply repeat adding layers in alternating directions until the desired height is reached.
Up to a maximum of 150cm (60”). Before building the top layer see the next step.
Step 06
Depending on the stack configuration, the top layer of blocks may need to be turned on their side to allow for a flat top surface. See reference table below.
